[Visual Basic]

control.AppendAutomationItemAddFromFileRaw (

strPathname as String,,

nEncodeMode as enumRAWEncodeModes,

bIsBigEndian as enumBoolean,

nFrequency as Long,

nChannels as Long,

nStartPosition as Long,

nEndPosition as Long,

fVolume as Single

) as enumErrorCodes

[C++]

short control.AppendAutomationItemAddFromFileRaw (

LPCTSTR strPathname,

short nEncodeMode,

short bIsBigEndian,

long nFrequency,

long nChannels,

long nStartPosition,

long nEndPosition,

float fVolume

);

Parameter

Description

strPathname

String representing the absolute pathname of the source sound file.

nEncodeMode

Encode mode used to encode the RAW file.

Supported values are the following:

bIsBigEndian

Boolean flag that specifies if bits order inside the RAW file are little-endian or big-endian

Supported values are the following:

nFrequency

Sample rate of the RAW file (e.g. 44100)

nChannels

Number of channels of the RAW file: 1 for Mono or 2 for Stereo

nStartPosition

Start position, expressed in milliseconds, of the range to load from the added sound file

nEndPosition

End position, expressed in milliseconds, of the range to load from the added sound file

fVolume

Volume level applied to the added song when it will be appended.

Supported values are expressed with a linear volume in the range from 0 to 100. In case you should need to set a volume expressed in dB, before setting this parameter you could convert the value in dB into a linear value through the following formula (C syntax):

VolumeLinear = 100 * pow (10, VolumeInDB/20);

Value

Meaning

Negative value

An error occurred, check the LastError property value in order to see the error code meaning

enumErrorCodes.ERR_NOERROR (0)

The method call was successful.