[Visual Basic]

control.VolumeAutomation.PointAdd (

nPlayer as Integer,

strVolumePointName as String,

fPosition as Single,

fVolumeLevel as Single,

nCurveType as enumVolumeCurves,

nDesignerUniqueId as Long

) as enumErrorCodes

[C++]

short control.VolumeAutomation.PointAdd (

short nPlayer,

LPCTSTR strVolumePointName,

float fPosition,

float fVolumeLevel,

short nCurveType,

long nDesignerUniqueId

);

Parameter

Description

nPlayer

Number representing the zero-based index of the involved player

strVolumePointName

String representing the friendly name of the volume point to add: there is no naming convention so you are free to decide your own set of names. This name will be used in next calls that will act on this specific volume point.

fPosition

Position of the volume point expressed in the same unit set into the VolumeAutomation.PositionUnit property.

fVolumeLevel

Volume level expressed in the same unit set into the VolumeAutomation.ScaleType property

nCurveType

Type of curve applied to reach the next volume point.

Supported values are the following:

nDesignerUniqueId

Unique identifier of the curve editor control containing custom curve settings to apply. This unique identifier is returned by a previous call to the VolumeAutomation.CurveDesigner.Create method.

The custom curve designer manages a windowed control, whose visual aspect can be defined programmatically, which allows designing volume curves based upon Bézier curves whose shape is defined through the manual positioning of 2 control points (displayed in cyan color on the graphic below). For further information about the use of the embedded CurveDesigner refer to the tutorial How to create custom volume curves.

This parameter is ignored if the nScaleType parameter above has been set to a value different from VOLUME_CURVE_CUSTOM.

Value

Meaning

enumErrorCodes.NOERROR (0)

The method call was successful

Negative value

An error occurred: see the LastError property for further error details or for a list of the possible error values.